Visit The Outboard Wizard’s website for genuine BRP OMC Evinrude parts at 10-50% off list prices.
robertgleason
I would like to know if I would be able to swap drive shafts from a 1990 lower unit to a 1995 lower unit. Both units are identical except for the driveshafts which differ in length by approx. 1/4-1/2 of an inch. I am trying to use the 1995 unit on my 1990 motor.

Robert

Robert
Quote 0 0
outboardwizard

Hello willl need to check if oring groove on top is the same thickness. if not the longer driveshaft will cause gear failure.

Ralph, The Outboard Wizard
Owner, Lindenhurst Outboard Service Inc. since 1979 +
Websites: "Outboard-Wizard" a few domains since 2001 - 
Ebay Store: Outboard Wizard  The Outboard Wizard - Power Seller
You Tube: See me here!
Quote 0 0