Visit The Outboard Wizard’s website for genuine BRP OMC Evinrude parts at 10-50% off list prices.
wade
1973 evinrude 115hp hard to start!!!!!

i purchased this motor a couple months ago,when my 1988 150 blew. the motor was suppose to of had a carb job and a power pack installed last fall.when you try to crank the motor for the first time of the day i raise the cold start hit the choke and it will fire after that you have to wind on it pretty good and it will fire off and on then as it begins to fire with the starter engaged you can raise the cold start and it will run.(this process may take 5-10 min). usually the rest of the day all you have to do is bump the starter and it will start. sounds like it is flooding after the initial firing!!. any suggestions!!
Quote 0 0
outboardwizard

Hello you will need to check spark with plugs in and then removed. a weak sensor will only have spark on 1 or 2 cylinders when cold.will need to adjust sensors or increase cranking speed to get spark on all cylinders when cold.

Ralph, The Outboard Wizard
Owner, Lindenhurst Outboard Service Inc. since 1979 +
Websites: "Outboard-Wizard" a few domains since 2001 - 
Ebay Store: Outboard Wizard  The Outboard Wizard - Power Seller
You Tube: See me here!
Quote 0 0
wade

thank you for your help!!

Quote 0 0